COM-1010PRO specification
| Leak detection display | According to the numerousness of the amounts of air leaks, it displays on the digital liquid-crystal-display machine of 0-100. |
| Sensitivity adjustment | According to the numerousness of the amounts of air leaks, it is changed in a range of a maximum of 60 dB. 1-64 steps of digital sensitivity adjustments |
| Leak detection frequency | 40KHz |
| Leak detection sound output | Leak detection sound is outputted to a headset jack. (Monophonic signal output) |
| Switch | Power switch, Sensitivity adjustment switch ▲, A sensitivity adjustment switch.▼ |
| Auto power OFF | A power supply is shut off after 30 minutes from operation of a switch. |
| Battery Loule Bell detection | It is a LOBAT display when a dry cell is exhausted. |
| Power supply | Four AA alkaline dry cells, A hour of use is about 30 hours. |
| Power consumption | About 210 mW |
| Outer diameter size | Length 165 mm (35 mm of + sensors) x Width 80 mm x Height 35 mm |
| Weight | 255g (A dry cell is not included) |
| The amount display of air leaks | 【The amount measurement of air leaks】 Measurement distance 0.1m , pressure 0.1MPa , 0.000L/ minute - 1.100L/ minute Measurement distance 1.0m , pressure 0.3MPa , 0.0L/ minute - 22.9L/ minute Measurement distance 3.0m , pressure 0.5MPa , 0.0L/ minute - 84.3L/ minute |
| Measurement distance setup | 【The amount measurement of air leaks】 Five kinds 0.1m (The amount measurement mode of very small leaks), 0.5, 1.0, 2.0, 3.0m |
| Pressure setup | 【The amount measurement of air leaks】] Seven kinds 0.1, 0.2, 0.3, 0.4, 0.5, 0.6, 0.7MPa |
| LED level indication setup | LED lights up according to the level of an air leak signal. 10, 20, 30, 40, 50, 60, 70, 80, 90 |
| Accessories | Case, The case protective cover made of rubber, Stereo headphone, Phon, Laser pointer, Four AA alkaline dry cells, Operation manual |
| 1. The amount of air leaks is based on the data which measured the ideal
air leak, Please understand that a numerical value may not suit depending on air leak measurement conditions. |
||
| 2.3.0 m of the amount measurement distance setup of leaks is the distance
set up when displaying the quantity which leaks from piping instead of
the maximum detecting ability. If detecting ability has many amounts of leaks, it can be detected even from the distantly distant place. |